Shine Veneer Dryer Introduction
The roller conveyor or wire-mesh conveyor in conventional mechanical veneer dryers aids in the drying by transferring heat by conduction to the veneer surface. Some investigators have reported that the heat transfer from the rolls may be as much as 20 percent of the total heat transferred to the veneer. This heat transfer from the rolls is very obvious when comparing the drying rates of veneer through an essentially empty dryer and one in which the conveyor is full of veneer. In the full dryer, the rolls are cooled by the wet veneer and the required drying time for a given final moisture content increases. This means the first veneer through an empty dryer will emerge much drier than veneer coming from a full dryer. If the drying time is set according to the first veneer through the dryer, the time will be too short and veneer coming from a full dryer will be much higher in moisture content.
Main Pictures of Shine Veneer Dryers
Technical Parameter for Shine Veneer Dryer
Parameter Model |
DHS44M
| DHS48M | DHS52M | DHS56M | DHS60M |
Work width(m) | 3 | 3 | 3 | 3 | 3 |
Layer | 2 | 2 | 2 | 2 | 2 |
Veneer thickness(mm) | 0.5-5 | 0.5-5 | 0.5-5 | 0.5-5 | 0.5-5 |
Heating area (m)
| 40 | 44 | 44 | 48 | 52 |
Cooling area (m) | 4 | 4 | 4+4 | 4+4 | 4+4 |
Initial water content(%) | 50-80 | 50-80 | 50-80 | 50-80 | 50-80 |
Finished water content(%) | 10 | 10 | 10 | 10 | 10 |
Drying capacity (m³/h) | 2.7-3.1 | 3-3.3 | 3.2-3.5 | 3.5-3.8 | 3.8-4.1 |
Heat exhaustion(10000 kcal) | 94.5-108.5 | 105-115.5 | 112-122.5 | 122-132 | 132-143 |
Traction motor power(kw) | 5.5*2 | 7.5*2 | 7.5*2 | 7.5*2 | 7.5*2 |
Hot air fan power (kw) | 11*10 | 11*11 | 11*11 | 11*12 | 11*13 |
Air cooling fan power(kw) | 11 | 11 | 11*2 | 11*2 | 11*2 |
Total power (kw) | 132 | 147 | 158 | 169 | 180 |
Overall size LxWxH(m) | 44*4.5 | 48*4.5 | 52*4.5 | 56*4.5 | 60*4.5 |
Copyright By © Shandong Shine Machinery Co.,Ltd